![]() There are usually three tabs on the top of the control board and three on the bottom (on the back). - If your control board does not have screws on the front, it will have tiny plastic tabs on the back of it that need to be compressed for the control board to pop out the front of the hopper.- If your control board has two screws on the front of it, remove them, then take the control board out the front of the hopper or feed it back inside the hopper and out the bottom of the hopper.Follow these directions to check the fuse: The fuse is on the back of the control board in a little green box. - Plug in the unit and turn it on to see if that resolved the issue.- With the hopper access panel removed, disconnect and then reconnect the power connection wires (black/white). ![]() Check the power connection on the back of the control board. If the cord is damaged, then you can contact our Pit Boss Customer Care Team for further assistance.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |